Johnson Controls | Siemens | Belimo | York | Schneider Electric | Trane | Sick | ASCO | DwyerOmega | Bell & Gossett | Honeywell | IMO Automation | Pepperl+Fuchs | Fireye | Eaton | Carrier | Square D and many more!

// 500+ Brands

// Authorized Distributor of Over 100 Brands

(800) 356-8000hello@cappusa.com//Cart
All ProductsDwyer

Dwyer 2000-00AV

SKU: CS3028719MPN: 2000-00AVAlternate Part #: 102042-10

2000-00AV MAGNEHELIC GAGE

Dwyer 2000-00AV, 2000-0AV, 2002AV, 2010AV
$153.76
Unit
Available on backorder
remove
add

Product Details

Differential Pressure Gauge Gauge Nominal Dial Size 4 in Basic Gauge Case Material Metal Differential Gauge Connection Type FNPT Differential Gauge Connection Size ⅛ in Gauge Connection Location Back and Side Differential Pressure Range Units in wc Differential Pressure Range Value 0 to 0.25 Gauge Accuracy +/-4.00 Percent Body Material Die Cast Aluminum Gauge Primary Range Smallest Graduation 0.005 Gauge Operating Temp Range 20 Degrees to 140 Degrees F

Attributes

Accuracy ±2% (-HA model ±1) of FS (±3% (-HA ±1.5%) on -0, -100PA, -125PA, -10MM and ±4% (-HA ±2%) on -00, -60PA, -6MM ranges), throughout range at 70°F (21.1°C).
Commodity Code 1200
Compliance Meets the technical requirements of EU Directive 2011/65/EU (RoHS II). Note: -SP models not RoHS approved.
Enclosure Rating IP67.
Housing Die cast aluminum case and bezel, with acrylic cover, Exterior finish is coated gray to withstand 168 hour salt spray corrosion test.
Mounting Orientation Diaphragm in vertical position. Consult factory for other position orientations.
Overpressure Relief plug opens at approximately 25 psig (1.72 bar), standard gages only. See Overpressure Protection note on Catalog page.
Pressure Limit -20 in Hg. to 15 psig.x0080  (-0.677 bar to 1.034 bar); MP option: 35 psig (2.41 bar), HP option: 80 psig (5.52 bar).
Process Connection ⅛” female NPT duplicate high and low pressure taps - one pair side and one pair back.
Service Air and non-combustible, compatible gases (natural gas option available). Note: May be used with hydrogen. Order a Buna-N diaphragm. Pressures must be less than 35 psi.
Size 4” (101.6 mm) diameter dial face.
Standard Accessories Two ⅛” NPT plugs for duplicate pressure taps, two ⅛” pipe thread to rubber tubing adapters and three flush mounting adapters with screws. (Mounting and snap ring retainer substituted for three adapters in MP & HP gage accessories.)
Wetted Material Consult factory.

Specifications

SKUCS3028719
MPN2000-00AV
Alternate Part #102042-10

You may also like