KMC

Controller: VAV, Universal, 0-2”, 8 PSI Start

Transducer: E/I-P, OVERRIDE

Controller: VAV, Universal, 0-1”, 8 PSI Start

Controller: VAV, Universal, 0-2”, 8 PSI Start, High Flow

Actuator: 4”x4”, 8-13 PSI, Bare, Clevis

Actuator: 3”x3”, 8-13 PSI, Bare, Standard

Controller: VAV, Universal, 0-1”, 3 PSI Start

Accessory: CMC-1001 Feedback Spring, 4”, 5 PSI, Pack of 5

Controller: VAV, Universal, 0-1”, 8 PSI Start, No Bracket

Valve; ½” 3 Way, NPT, Diverting; 2.5 Cv; 3-8 PSI; Fail AB - A

Relay: Reversing, 9 PSI, High Capacity, Bracket

Accessory: Crank Arm, ½” Slotted, Long, Pack of 5

Accessory: Universal Short Mount

6” Plastic Feedback Spring (10 PSI)

Controller: VAV, RA/NC, 0-1”, Molded Dial, Gray

Accessory: CMC-1001 Feedback Spring, 3”, 5 PSI, Pack of 5

Actuator: Proportional, Failsafe, 24VAC/VDC, 320 in-lbs

Pneumatic Kit: Fan Powered VAV with Electric Reheat

Pneumatic Kit: Fan Powered VAV with Water Reheat, 22K BTU

Pneumatic Kit: Fan Powered VAV with Water Reheat, 56K BTU

Controller: Receiver, 2 Pipe

Dual Input Receiver Controller w/ Remote Setpoint Adjustment (Low Volume)

Pneumatic Kit: Cooling Only

Two-Pipe Pneumatic Room Reverse-Acting Thermostat Vertical F. Value Package (55° to 85°F)

Valve; ½” 3 Way, NPT, Diverting; 2.5 Cv; 8-13 PSI; Fail AB - A

Tstat: 2-pipe, RA

Tstat: 2-pipe, DA

3-12 PSI REAR POST-MOUNTED

Accessory: CMC-1001 Feedback Spring, 6”, 5 PSI, Pack of 5

PUSH ROD FOR MCP-8031 SERIES (5/Pkg Min Qty)

4” Standard Body “Bare” Pneumatic Actuator, 8 - 13 PSI with 4” Stroke

Actuator: 3”x3”, 8-13 PSI, Bare, Clevis

Actuator: 3”x3”, 8-13, Bare, Delrin Bushing

Actuator: 3”x3”, 5-10 PSI, Bare, Standard

Controller: VAV, Universal, 0-1”, 10 PSI Start

Controller: VAV, Universal, 0-2”, 3 PSI Start

PNEU ACT/8-13 PSI/BRZ BUSHING/LINKAGE ½ SHAFT

Actuator: Metal, 1-11/16”, 4-8 PSI, ½” Crank Arm

Relay: Reversing, 8 PSI, High Capacity, Bracket

Relay: Reversing, 8 PSI, High Capacity

Relay: Reversing, 9 PSI, High Capacity

Accessory: Crank Arm, ⅜”, 3-Hole, Pack of 5

Actuator: Metal, 1-11/16”, 5-10 PSI, ½” Crank Arm

Actuator: 2”x2”, 5-10 PSI, Bare, Standard

Actuator: 2”x2”, 8-13 PSI, Bare, Standard

BACnet MS/TP Tstat Hardwire Air Handling

Controller: VAV, DA/NO, 0-1”, Molded Dial, Beige

Actuator: 3”x3”, 8-13 PSI, ⅜” Crank Arm

Accessory: Ball Joint, ¼”-20 male for end-mounted 5/16” rods, Pack of 5

Actuator: 3”x3”, 5-10 PSI, ½” Crank Arm

Actuator: 2”x2”, 8-13 PSI, ½” Crank Arm

Actuator: 4”x4”, 8-13 PSI, ½” Crank Arm

Actuator: 2”x2”, 3-12 PSI, Ball Joint

Actuator: 4”x4”, 8-13 PSI, Ball Joint

Actuator: 6”x6”, Positioner, No Linkage

Actuator: 4”x4”, 8-13 PSI, Post Mount